FRINK Linked Data Fragments server

Matches in SemOpenAlex for { <https://semopenalex.org/work/W2080345088> ?p ?o ?g. }

• W2080345088 endingPage "685" @default.
• W2080345088 startingPage "677" @default.
• W2080345088 abstract "Introduction Electricité de France have always attached considerable importance to improving power plant equipment efficiency, as a result of which full-discharge feed pump outputs have shown a spectacular increase over the last ten years (see Table 1). With a view to further improvement of the availability of such equipment, EDF have now set themselves the two following additional standards : a) feed pumps must be able to operate for one minute under vaporizing conditions. b) Internal pump assemblies must be designed for rapid replacement, i.e. in a few hours. General feed pump design features Basic features Each output range is catered for by a single full-discharge feed pump set comprising the pump and its turbine drive, reduction gear and auxiliary feed pump on a common shaft assembly. Number of stages The one-minute vaporization requirement implies a rigid shaft, and therefore, no more than three stages, not exceeding 650 m. Hydraulic design Hydraulic characteristics Discharge/head curve Pump geometry must be designed for a stable, continuous downward discharge/head characteristic. Efficiency Since efficiency falls off with specific speed, excessive stage heads are undesirable. Efficiency also decreases if radial clearances are widened with a view to minimal risk of rotor/stator contact under vaporizing conditions (see Fig. 2). Cavitation problems The risk of erosion can be eliminated by determining the critical NPSH by visual observation of cavitation figures on a scale model. There is no general relationship between industrial (NPSH)c and critical erosion (NPSH)f' (see Figs. 3 and 4). Fluctuating pressure Clearance geometry between the impeller and diffuser requires very careful determination to reduce pressure fluctuations to a minimum, especially at low discharge. Hydraulic thrust Calculated data have been checked by model tests and corrected to allow for such factors as the effect of leakage or various radial and axial clearances, etc. Mechanical design General Even temperature distribution and mechanical stability of the impeller are most important design requirements. The active pump components are designed as a barrel assembly with mechanical shaft seals and hydrodynamic bearings with pivoting segments (see Fig. 5). Special features of pumps for above 700 MW Sub-critical rigid impeller assembly. Axial balance ensured by a barrel assembly and double-acting segment thrust bearing. Mechanical seals tested on a special EDF-designed rig (see Figs. 6 and 7). Special self-sealing boltless head cover fitting arrangement, allowing rapid dismantling of the internal pump component assembly (see Figs. 8 and 9). Conclusion The first pumps of this type were commissioned at the beginning of 1977. They have successfully passed one-minute vaporizing tests on site and proved satisfactory in subsequent service." @default.
• W2080345088 created "2016-06-24" @default.
• W2080345088 creator A5015200428 @default.
• W2080345088 creator A5027476139 @default.
• W2080345088 creator A5027741860 @default.
• W2080345088 date "1977-11-01" @default.
• W2080345088 modified "2023-10-14" @default.
• W2080345088 title "Les pompes alimentaires multicellulaires du palier 700 MW et au-delà" @default.
• W2080345088 doi "https://doi.org/10.1051/lhb/1977050" @default.
• W2080345088 hasPublicationYear "1977" @default.
• W2080345088 type Work @default.
• W2080345088 sameAs 2080345088 @default.
• W2080345088 citedByCount "0" @default.
• W2080345088 crossrefType "journal-article" @default.
• W2080345088 hasAuthorship W2080345088A5015200428 @default.
• W2080345088 hasAuthorship W2080345088A5027476139 @default.
• W2080345088 hasAuthorship W2080345088A5027741860 @default.
• W2080345088 hasBestOaLocation W20803450881 @default.
• W2080345088 hasConcept C108338728 @default.
• W2080345088 hasConcept C114088122 @default.
• W2080345088 hasConcept C114793014 @default.
• W2080345088 hasConcept C121332964 @default.
• W2080345088 hasConcept C127313418 @default.
• W2080345088 hasConcept C127413603 @default.
• W2080345088 hasConcept C153005164 @default.
• W2080345088 hasConcept C166675230 @default.
• W2080345088 hasConcept C17281054 @default.
• W2080345088 hasConcept C207057113 @default.
• W2080345088 hasConcept C2776529397 @default.
• W2080345088 hasConcept C2778449969 @default.
• W2080345088 hasConcept C2780312720 @default.
• W2080345088 hasConcept C39432304 @default.
• W2080345088 hasConcept C56673219 @default.
• W2080345088 hasConcept C57879066 @default.
• W2080345088 hasConcept C65120314 @default.
• W2080345088 hasConcept C78519656 @default.
• W2080345088 hasConcept C90417339 @default.
• W2080345088 hasConceptScore W2080345088C108338728 @default.
• W2080345088 hasConceptScore W2080345088C114088122 @default.
• W2080345088 hasConceptScore W2080345088C114793014 @default.
• W2080345088 hasConceptScore W2080345088C121332964 @default.
• W2080345088 hasConceptScore W2080345088C127313418 @default.
• W2080345088 hasConceptScore W2080345088C127413603 @default.
• W2080345088 hasConceptScore W2080345088C153005164 @default.
• W2080345088 hasConceptScore W2080345088C166675230 @default.
• W2080345088 hasConceptScore W2080345088C17281054 @default.
• W2080345088 hasConceptScore W2080345088C207057113 @default.
• W2080345088 hasConceptScore W2080345088C2776529397 @default.
• W2080345088 hasConceptScore W2080345088C2778449969 @default.
• W2080345088 hasConceptScore W2080345088C2780312720 @default.
• W2080345088 hasConceptScore W2080345088C39432304 @default.
• W2080345088 hasConceptScore W2080345088C56673219 @default.
• W2080345088 hasConceptScore W2080345088C57879066 @default.
• W2080345088 hasConceptScore W2080345088C65120314 @default.
• W2080345088 hasConceptScore W2080345088C78519656 @default.
• W2080345088 hasConceptScore W2080345088C90417339 @default.
• W2080345088 hasIssue "7-8" @default.
• W2080345088 hasLocation W20803450881 @default.
• W2080345088 hasLocation W20803450882 @default.
• W2080345088 hasOpenAccess W2080345088 @default.
• W2080345088 hasPrimaryLocation W20803450881 @default.
• W2080345088 hasRelatedWork W2004928877 @default.
• W2080345088 hasRelatedWork W2072169877 @default.
• W2080345088 hasRelatedWork W2353660998 @default.
• W2080345088 hasRelatedWork W2379687319 @default.
• W2080345088 hasRelatedWork W2891818060 @default.
• W2080345088 hasRelatedWork W3117013974 @default.
• W2080345088 hasRelatedWork W623971891 @default.
• W2080345088 hasRelatedWork W633077811 @default.
• W2080345088 hasRelatedWork W639092995 @default.
• W2080345088 hasRelatedWork W2188129543 @default.
• W2080345088 hasVolume "63" @default.
• W2080345088 isParatext "false" @default.
• W2080345088 isRetracted "false" @default.
• W2080345088 magId "2080345088" @default.
• W2080345088 workType "article" @default.