FRINK Linked Data Fragments server

Matches in SemOpenAlex for { <https://semopenalex.org/work/W3048658950> ?p ?o ?g. }

• W3048658950 endingPage "119839" @default.
• W3048658950 startingPage "119839" @default.
• W3048658950 abstract "Abstract This paper presents an extensive experimental study of the effect of surface characteristics on the bond behaviour of Fibre Reinforced Polymer (FRP) bars in concrete. A wide range of commercially available FRP bars with different surface profiles (total of 13 different surface configurations) were involved. For comparison, ribbed steel bars were used. To investigate whether the effect of surface characteristics is in interaction with other factors, further parameters were included in the study such as concrete compressive strength (35 and 66 MPa), bar diameter (6 to 12 mm) and test type (pull-out [P-O] and direct tension [DT] pull-out). This resulted a total of 200 P-O and 38 DT tests. DT test method was developed by the authors based on a similar test setup from the literature. Surface finish of the investigated FRP bars include sand coated (SC), helically wrapped (HW), helically wrapped and sand coated (HWSC), indented (In) and ribbed (Rb). Most of the applied bars are Glass FRP (GFRP), however, due to the similar physical and mechanical properties Basalt FRP (BFRP) bars were used as well. The bond behaviour of the bars was evaluated by bond strength, bond stress-slip relationship, representative bond stresses and failure mode. It was found that the bond strength as well as bond stress-slip behaviour and failure mode vary considerably depending on surface characteristics. Furthermore, even within the same surface category the bond strength difference can be significant (e.g., SC surface with different sand fineness). The concrete strength influences the bond strength even if it is higher than the limit stated in literature (approximately 30 MPa). Furthermore, the bond strength results of all FRP bars were consistently higher than those of steel bars. The highest slip value to reach the bond strength was observed for HW FRP bars, while the lowest for SC bars. Some results reported in this paper considerably differ from those previously reported in other papers based on testing similar bars. The difference, in terms of bond strength, can be explained by the alteration of surface configuration, the improvements in material properties and fabrication processes. Finally, the test setup was found to affect the measurable bond strength." @default.
• W3048658950 created "2020-08-18" @default.
• W3048658950 creator A5051626546 @default.
• W3048658950 creator A5084366839 @default.
• W3048658950 date "2020-12-01" @default.
• W3048658950 modified "2023-10-16" @default.
• W3048658950 title "Bond of FRP bars with different surface characteristics" @default.
• W3048658950 cites W1976753170 @default.
• W3048658950 cites W1979659224 @default.
• W3048658950 cites W1980584162 @default.
• W3048658950 cites W1988432363 @default.
• W3048658950 cites W1994997039 @default.
• W3048658950 cites W1997300581 @default.
• W3048658950 cites W1998034205 @default.
• W3048658950 cites W2001779850 @default.
• W3048658950 cites W2033463360 @default.
• W3048658950 cites W2035193434 @default.
• W3048658950 cites W2045240081 @default.
• W3048658950 cites W2045526541 @default.
• W3048658950 cites W2045735107 @default.
• W3048658950 cites W2049252553 @default.
• W3048658950 cites W2064842938 @default.
• W3048658950 cites W2066203345 @default.
• W3048658950 cites W2089834397 @default.
• W3048658950 cites W2131662566 @default.
• W3048658950 cites W2294976613 @default.
• W3048658950 cites W2298027384 @default.
• W3048658950 cites W2353243849 @default.
• W3048658950 cites W2478420640 @default.
• W3048658950 cites W2548259308 @default.
• W3048658950 cites W2550873431 @default.
• W3048658950 cites W2604207209 @default.
• W3048658950 cites W2611351791 @default.
• W3048658950 cites W2616649059 @default.
• W3048658950 cites W2735770310 @default.
• W3048658950 cites W2985450452 @default.
• W3048658950 cites W3048658950 @default.
• W3048658950 cites W4243898376 @default.
• W3048658950 cites W55310438 @default.
• W3048658950 doi "https://doi.org/10.1016/j.conbuildmat.2020.119839" @default.
• W3048658950 hasPublicationYear "2020" @default.
• W3048658950 type Work @default.
• W3048658950 sameAs 3048658950 @default.
• W3048658950 citedByCount "80" @default.
• W3048658950 countsByYear W30486589502020 @default.
• W3048658950 countsByYear W30486589502021 @default.
• W3048658950 countsByYear W30486589502022 @default.
• W3048658950 countsByYear W30486589502023 @default.
• W3048658950 crossrefType "journal-article" @default.
• W3048658950 hasAuthorship W3048658950A5051626546 @default.
• W3048658950 hasAuthorship W3048658950A5084366839 @default.
• W3048658950 hasBestOaLocation W30486589501 @default.
• W3048658950 hasConcept C10138342 @default.
• W3048658950 hasConcept C111368507 @default.
• W3048658950 hasConcept C127313418 @default.
• W3048658950 hasConcept C127413603 @default.
• W3048658950 hasConcept C144133560 @default.
• W3048658950 hasConcept C159985019 @default.
• W3048658950 hasConcept C188721877 @default.
• W3048658950 hasConcept C192562407 @default.
• W3048658950 hasConcept C2524010 @default.
• W3048658950 hasConcept C2776799497 @default.
• W3048658950 hasConcept C33923547 @default.
• W3048658950 hasConcept C66938386 @default.
• W3048658950 hasConcept C69738904 @default.
• W3048658950 hasConcept C76344452 @default.
• W3048658950 hasConcept C77595967 @default.
• W3048658950 hasConceptScore W3048658950C10138342 @default.
• W3048658950 hasConceptScore W3048658950C111368507 @default.
• W3048658950 hasConceptScore W3048658950C127313418 @default.
• W3048658950 hasConceptScore W3048658950C127413603 @default.
• W3048658950 hasConceptScore W3048658950C144133560 @default.
• W3048658950 hasConceptScore W3048658950C159985019 @default.
• W3048658950 hasConceptScore W3048658950C188721877 @default.
• W3048658950 hasConceptScore W3048658950C192562407 @default.
• W3048658950 hasConceptScore W3048658950C2524010 @default.
• W3048658950 hasConceptScore W3048658950C2776799497 @default.
• W3048658950 hasConceptScore W3048658950C33923547 @default.
• W3048658950 hasConceptScore W3048658950C66938386 @default.
• W3048658950 hasConceptScore W3048658950C69738904 @default.
• W3048658950 hasConceptScore W3048658950C76344452 @default.
• W3048658950 hasConceptScore W3048658950C77595967 @default.
• W3048658950 hasLocation W30486589501 @default.
• W3048658950 hasOpenAccess W3048658950 @default.
• W3048658950 hasPrimaryLocation W30486589501 @default.
• W3048658950 hasRelatedWork W1967063022 @default.
• W3048658950 hasRelatedWork W2006118778 @default.
• W3048658950 hasRelatedWork W2018752562 @default.
• W3048658950 hasRelatedWork W2329379447 @default.
• W3048658950 hasRelatedWork W2382427077 @default.
• W3048658950 hasRelatedWork W2391698654 @default.
• W3048658950 hasRelatedWork W2909495256 @default.
• W3048658950 hasRelatedWork W4248201063 @default.
• W3048658950 hasRelatedWork W4292484877 @default.
• W3048658950 hasRelatedWork W4311689990 @default.
• W3048658950 hasVolume "264" @default.
• W3048658950 isParatext "false" @default.
• W3048658950 isRetracted "false" @default.

• next